WIRING PROBLEM???????

Is it possible if you are running 2 dual two ohm subs to the same channel,(in parallel) you get to a .5 ohm right.Now, is it possible to wire them to get a 1ohm load????HOW

No. You cannot wire them together and get a 1 ohm load. I am running 2 D2's now in parallel at .5. Only other option it 2 ohm.

You can wire them separate in parallel at 1 ohm though.

yes it possible all you do is use 1 coil per sub, an wire them down to 1 ohm

2/2=1ohm

now i know this is the next question will that hurt my subs answer is no coils are wound togather a dual voice coil just means pushin the power on 2 side of the coil instead of 1 side wich means it fluters faster. I run subs like this alot just to test amp at differant ohm loads

Well, I wouldn't think someone would want to do that. But who knows.

But then again it didn't even cross my mind

its been done in both burp apps, and street beat and it works

Does it change the sound at all? Or output of woffa?

possibility i guess since there isnt as much current goin to it

Well then, there are all your options.

What ohms would i be running if i hook up a single negative from the left sub to the amp. then take a single positive from the right sub and hook it up to the amp. then spliced the extra postive and negative wires together (not being hooked up to the amp) tape them. wouldnt that leave me at .75 ohms.... or 1ohm

This??

close but not quite should i make a video or maybe take pics???[/url]

Pics FTW