soundstream xxx-6500, 6 coils, 3 dust caps, 15" cone

I'm not on here as often, but have great feedback on caraudioclassifieds.org, CA.com and ebay. I also met a few of you guys in Tulsa last year. I thought this stuff could use a good home with fellow competitors. can also email me, spudnugget2004@yahoo.com


1(one) soundstream xxx-6500 (I had 2)

used but 8.5 out of 10 for normal scratches
still in my car, and did a 155.1 db 2 weeks ago with both amps

$700 shipped

RMS Power @ 2 Ohm, 14.4V 3,300
RMS Power @ 1 Ohm, 14.4V 5,300
RMS Power @ 1 Ohm, 16V 6,500
Total Harmonic Distortion 5.00%
Frequency Response 15-150Hz
Signal-to-Noise Ratio 80dB
Damping Factor 350
Signal Voltage 500mV-10V
Potential Current Draw 460A
Dimensions: 2.625"h x 11.375"w x 25.75"L




4 coils, all 4 layer flat wound, all slightly used and been in acetone to get glue off. from left to right

was a MT D1, 3" ID 3.375" OD 2" ww 4.6" former
D1, 3" ID 3.25" OD 2.25" ww 3.625" former
D1, 3" ID 3.25" OD 2.25" ww 4.125" former
D1.5, 3" ID 3.1875" OD 2.25" ww 4.125" former $20 each


2 2-layer round wound brand new
D0.6, 3" ID 3.25" OD 2.25" WW 4.125" former


3 dust caps 5 1/4" 1 new 2 used $10 each

15" cone high roll surround, has a tear becuase some thing got stuck on it, but its just the top there and should be able to glue back down $15

hey man you sure them mt 3.25 are only 4 layer? thats pretty close to a mt 8 layer measurement.. anyway, the 3.18 4 layers , is there anything left to solder too? and how much for the 2 brand new d .06 coils?

thats a great point, and yes in the 1st picture its on the far left, i'd say 2 inch of lead

how about $30,