?s about maxxlink as a line driver

Guys if you use maxxlink as a line driver only do you still set it up the same way as a strapping module? do you have to use a dmm to set each amp voltage? using it to provide good signal to four amps so i dont have to use a bunch of y splitters and lose a lot of signal jus not sure how to use it as line driver can you run one rca from hu and then use the outputs on maxxlink to send to each amplifier will this work this way???

i use mine with 4 autotek mm4000s they are basicly 2 2000s straped each you have to use a y splitter on each output on the maxxlink on the top row of outputs

not using it as a strapp module

why do you need y splitters? the maxxlink has multiple outputs why do you need them i thought u could jus plug rca from maxxlink to amps no splitters?

4 amps only 5 top outputs was told to only use side a since i am not strapping amps

only doing what i was told to do thing herd this from mike at maxxsonics

cuz you have 5 pos rcas and 5 neg rcas the neg rcas (bottom row)reverse polarity to make your slave amp.......just like normally strapping your slave amp is the Negative side.........soooo to line drive use only the Postive rcas(top row)

cool guys thanx for help i understand what yall are saying now

no prob dude thats wat we all here for