Number of posts : 382 Location : Nebraska Registration date : 2007-06-26
Subject: box chambers Fri Jul 22, 2011 5:20 am
What is the general concensus on sub boxes. Is it better to have one chamber for 2 or more subs, or separate chambers for each sub, or does it make that much difference. I've usually ran separate chambers for each sub, but have never ran more than 2 subs in one setup.
I'm looking at rebuilding my foxbody mustang hatchback, and those things have a lot of room and will be running multiple subs. Should be able to fit either 4-15's, or 8 to 10 10's depending on the design.
Thanks Dan
chrisfish I own this joint!
Number of posts : 6521 Age : 54 Location : Silt Colorado Registration date : 2009-05-16
Subject: Re: box chambers Fri Jul 22, 2011 7:20 am
Common chamber has been loudest in my testing.
sanman I own this joint!
Number of posts : 12087 Age : 52 Location : shelbyville Registration date : 2007-06-23
Subject: Re: box chambers Fri Jul 22, 2011 11:54 am
common chamber for me was always loudest on power
on lack of power it was chambered
TAMU Advanced Contributor
Number of posts : 1548 Location : TEXAS Registration date : 2007-06-23
What is the general concensus on sub boxes. Is it better to have one chamber for 2 or more subs, or separate chambers for each sub, or does it make that much difference. I've usually ran separate chambers for each sub, but have never ran more than 2 subs in one setup.
I'm looking at rebuilding my foxbody mustang hatchback, and those things have a lot of room and will be running multiple subs. Should be able to fit either 4-15's, or 8 to 10 10's depending on the design.
Thanks Dan
dont know what a fox body is but 2 12s 1 up 1 to the side, port to the side does pretty dam good.
nebrsq Basic Contributor
Number of posts : 382 Location : Nebraska Registration date : 2007-06-26
Got a decent amount of power, so I'll try a common box.
THe mustang is an 89 hatch. I've got some 12's in the garage, not the best, but will work for testing.
As far as the ports, I've worked a lot with slot ports, but have not with aeroports. is there a quick conversion chart I can use to go from one to the other, or would I go just off of port area vs port area.