we need help programing a remote for code pc-7500? anyone?
call me 913-287-1556

Instructions for programming your new Code Alarm remote:

REMOTE TRANSMITTER PROGRAMMING
Note: Each System module has four “slots”, or memory locations, to store transmitter codes, giving it the ability to operate from up to four transmitters. For proper operation, a transmitter code must be stored into each memory slot. When using less than four transmitters, follow the suggested programming parameters:

• One Remote Transmitter – Program four (4) times
• Two Remote Transmitters – Program each transmitter two (2) times.
• Three Remote Transmitters – Program two transmitters one (1) time, and the remaining transmitter twice.

1. Open the driver’s door.
1a. The 20/B wire must initially see a negative input to access programming.
2. Turn vehicle ignition on.
3. Press and hold emergency override button.

After 10 seconds, the siren or horn will sound three (3) times. This indicates that the unit has entered the transmitter programming mode.
4. Release the button.
5. Press the ARM button on the remote transmitter to be programmed. The siren or horn will sound once, indicating that the system has “learned” that remote transmitter.
6. Repeat step 5 for any additional transmitters or transmitter codes.
7. Turn the vehicle ignition off to exit the programming mode. Test all remote transmitters to ensure that they work properly by toggling the LOCK and UNLOCK buttons.

I am not a code alarm dealer. did some research and came up with this. Hope it helps

ask swat i think danny or bill know